SpeakerCraft SC2-50 User Manual

16
www.SpeakerCraft.com
INSTALLATION
AC pOwER pLUG
CAUTION! Typically a preamp/receiver’s switched outlet is not rated for a
power amplier. The SC2-50, the SC2-100 and the SC2-150 draw 200 watts,
300 watts, and 400 watts maximum from an AC wall outlet respectively. Use a
dedicated AC wall outlet along with the amplier’s auto turn on circuit to ensure
adequate power.
STEP DESCRIPTION
1. Plug the female IEC socket of the
supplied AC power cord (the supplied
power cord is designed for 120V AC
wall outlets), or use an appropriate
IEC AC power cord to match the
electrical wall outlet you are using
(e.g. 240V AC), into the IEC receptacle
on the rear of the amplifier.
Just like a computer or printer, the
SpeakerCraft 2-Channel Amplifier
has an AC cord which unplugs
either at the amp or at the wall for
your convenience.
2. Plug the male end of the AC power
cord into a correctly grounded wall
outlet.
If you use a grounded power strip,
surge suppressor or extension
cord, verify that proper ground is
maintained.

SpeakerCraft SC2-50 Specifications

General

Brand	SpeakerCraft
Model	SC2-50
Category	Amplifier
Language	English