10 11AFTER SALES SUPPORT 01904 727505 www.spearandjackson-power.com www.spearandjackson-power.com AFTER SALES SUPPORT 01904 727505
Assemble inlet adapter.
Attach the inlet adapter (15) to the machine’s water
inlet. Hand tighten only.
Connect garden hose and water supply.
Attach garden hose to the water supply and
turn water on. Let little water run through the
hose then turn it off.
WARNING - Wear suitable clothing, ears and eyes
protecting when working with the equipment.
Ensure that the mains voltage value matches the
label on the equipment.
Stopping
i. Release the trigger, and replace the safety lock.
ii. To switch the machine off, set the On/Off switch to OFF.
iii. Close the water inlet valve.
ATTENTION! Risk of machine damage!
Never operate the machine without the water being
connected as dry running may damage the pump.
Use a water filter if the inlet water is contaminated.
Starting
i. Put the high pressure washer on level ground.
Stand in a secure and stable position.
Ii. Open the water inlet valve.
iIi. Unlock the safety trigger on the spray gun, and press
the trigger until there is a steady stream of water.
iv.
To switch the machine on, set the On/Off switch to ON.
Before starting
i. Check the machine for visual defects.
Ii.
Check that all parts of the machine have been securely fitted.
iIi. Check if the water connector and the high-pressure pipes
are tight.
Connect garden hose and inlet adapter.
Attach a hose with a quick connect coupling
(not included) to the high pressure washer. Turn
water on.
Connect socket.
Insert the mains plug into the socket.
ASSEMBLY OPERATION
4
5
6
7
8
OFF position.
Make sure the ON/OFF switch is in the
OFF position.
To Next Page
