AFTER SALES SUPPORT 0345 605 2070 13
OPERATE
2.Check the oil passes
Start the machine and check whether the chain can
give off a spray of oil within a few seconds. If an oil
trace can be seen, the pole saw is lubricating.
NOTE! Never saw when a sufficient chain lubrication
is not guaranteed. Before starting work check the oil
level in the tank and the oil feeding.
1.Safety lock button
2.Trigger
switch
To turn the tool ON, push and hold the safety lock
button with your thumb and then squeeze the trigger
with your fingers. Once the tool is running.
you release the safety lock button.
Release the trigger switch to stop the chain.
1. Switch on/off
Balance your weight with both feet on solid ground.
Your body should always be to the left of the chain
line.Grip handle tightly.The most typical cutting
application is to position the unit at an angle of 60°or
less depending on the specific situation. As the angle
of the pole chain saw shaft to the ground increases,
the difficulty of making the first cut (from the underside
of limb) increases.
3. Hold the machine
To Next Page
