Spectra 1641 - Options; Keypad Zone Sending

4 Installation Guide
[101] to [116] = Zone 1 to Zone 16
[133] = Partition 1
[134] = Partition 2
[135] = Keypad Name (default: “Paradox Security”)
[500] to [507] = Notes (this is what the user will see when the [HELP] key
is pressed)
[2] Options
In step 3 of “Entering Keypad Programming Mode” on page 3, select
option [2]. You will now be able to enable or disable the keypad’s
options as shown in Table 1. Press the corresponding keys until all
desired options are set, then press [
ENTER].
Table 1: Keypad Options
Bold = Default
Keypad Zone Sending
Section [2] — Option [1]
Off = Disabled
On = Enabled (default)
Key Description OFF ON
[1] Keypad Zone Sending
 Disabled  Enabled
[2] Keypad Zone Requires
1K
Ω EOL Resistor
 No  Yes
[3] Keypad Zone Set to
 Keypad Zone 1  Keypad Zone 2
[4] On-Board Keypad Tamper
Supervision
 Disabled  Enabled
[5] Status LED Follows
Arming Status of
 Partition 1  Partition 2
[6] Multiple Zone Display
 Disabled  Enabled
[7] Scrolling Zone Display
 Disabled (only if
[6] = ON)
 Enabled
[8] Time Format
 International  US (a.m./p.m.)