Spectra (1641) 7
indications (option [8] on).
• 18:00 = International (option [8] off)
• 6:00 p.m. = U.S. (option [8] on)
[3] Keypad Code
This feature permits you to change the Keypad Code (default:
000000). In step 3 of “Entering Keypad Programming Mode”(on
page 3), select section [3]. The keypad will now prompt you to enter
the new 6-digit Keypad Code. After entering the final digit you will
hear a confirmation beep. Please note that if you wish to reset the
Keypad Code to its default value, press and hold the [
CLEAR] key
during the keypad’s power up.
[4] Keypad PGM
This feature allows you to program the keypad’s on-board PGM
output. In step 3 of “Entering Keypad Programming Mode” (on
page 3), select section [4]. The keypad will now prompt you to enter
a two-digit value. Choose one of the three following PGM modes,
then press [
ENTER].
00 = Keypad’s PGM output is disabled
01 = Keypad’s PGM will follow the Global PGM event programmed in
the Spectra control panel
02 = The keypad’s PGM output is activated or deactivated by
pressing and holding the [
FNC1] key
[5] Read Key
Use this feature to copy the contents of a Paradox Memory Key into
the keypad’s memory. Insert a programmed Paradox Memory Key
(see "Write Key" on page 8) into the keypad connector labeled “key”
(see Figure 1 on page 23). In step 3 of “Entering Keypad
To Next Page
Loading...