EasyManua.ls Logo

Spectra S1 Plus - Use and Storage Conditions

Spectra S1 Plus
17 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Condition Possible Causes Check Solution
No Power
Adaptor
Is the power cord plugged in? Is
the power cord damaged?
Plug into the outlet. If it is damage
d, contact the manufacturer or the
vendor from whom you purchased
the pump.
Dead battery
(Spectra SI Plus Only
)
Is the battery fully charged?
If it doesn’t charge, contact the
manufacturer or the vendor from
whom you purchased the pump.
No Suction
Air tube
Is the tubing connected to the pu
mp?
Connect the air tube to the pump.
Valve
Are the valve and tube connecte
d to the breast shield properly?
Disassemble and reassemble the
parts properly.
Air cap Is the air cap closed? Close the air cap.
Low Suction
Vacuum Level
Is the vacuum level set too low? I
s the valve intact?
Is the pump making an odd
noise?
Contact the manufacturer or seller
of the pump.
Defective assembly
Are kit parts assembled properly
?
Disassemble and reassemble the
kit parts properly.
Breast shield Is the breast shield damaged?
Contact manufacturer to replace t
he breast shield.
Valve Is the valve damaged?
Contact manufacturer to replace t
he valve.
Pain Too high suction Is the cycle speed set too high?
Set to the lowest suction level and
see your lactation consultant
or health care professional for
advice.
Use and Storage Conditions

Other manuals for Spectra S1 Plus

Related product manuals