Spectracom 9183 - net mac Command

Page 7-18 Model 9183 Instruction Manual
7
7
.
.
1
1
7
7 net mac
The net subcommand, mac, is used to display the Ethernet MAC address for the unit. The mac
subcommand is intended for advanced users. The advanced user can use this command to
retrieve the Ethernet MAC address of the unit for uses such as network traffic monitoring.
The mac subcommand is available at the user security level to get the value.
To get the Ethernet MAC address for the unit, issue the mac subcommand as shown below:
Type: net mac <ent>
Response: MAC address: XX;XX;XX;XX;XX;XX
Where: XX;XX;XX;XX;XX;XX = The Ethernet MAC address for
the unit.
Note: The MAC address of the NetClock is configured at the factory and cannot be changed.