SpectraLink IP-DECT Server 200 - Spectralink DECT Server 2500 Specifications

14215700-IG, Edition 15.0
May 2020, Original document
18
Spectralink IP-DECT/Virtual IP-DECT
Server Solution
Types of Servers
Following types of servers are available:
l Spectralink IP-DECT Server 200
l Spectralink IP-DECT Server 400
l Spectralink IP-DECT Server 6500
l Spectralink Virtual IP-DECT Server One
Note:
Besides the Spectralink IP-DECT/Virtual IP-DECT Server solutions, a Spectralink
DECT Server solution is also available. The Spectralink DECT Server solution is out of
the scope of this Installation and Configuration Guide but will be mentioned in "Spec-
tralink Server Solution Overview and Comparison" on page32.
Description - Spectralink IP-DECT Server 200
The Spectralink IP-DECT Server 200 is a single cell system (one built-in base station in the server)
supporting SIP lines only.
The Spectralink IP-DECT Server 200 is designed with connector for External Antenna.
Up to 3 additional Spectralink DECT Repeaters can be added to the Spectralink IP-DECT Server
200.
The Spectralink IP-DECT Server 200 supports up to 12 registered handsets and 6 simultaneous
calls.
The DECT radius of coverage is up to 600 meters/2000 feet with a handset in free sight.
The DECT radius of coverage can vary significantly if obstacles block the signal, for example in build-
ings with many rooms, hallways, walls and floors. The radius coverage is typically around 30
meters/100 feet in office environments. Coverage should always be verified to ensure optimal loc-
ation of the Spectralink IP-DECT Server 200 before it is permanently installed.
Spectralink IP-DECT Server 200/400/6500 and Virtual IP-DECT Server One Installation and Configuration Guide