SpectraLink IP-DECT Server 400 - Page 176

14215700-IG, Edition 15.0
May 2020, Original document
176
Note:
“Paging” is about incoming voice and messaging calls, where the Spectralink IP-
DECT/Virtual IP-DECT Server has to send out an announcement (through the relevant
Spectralink IP-DECT Base Stations) asking the handset to chose a base station and
start establishing a connection.
With 2019 release 2 of the Spectralink IP-DECT Server firmware (PCS 19Bc) site base
paging has been implemented, and in 2019 release 2 (and only this release), site based
paging is automatically used, when configuring minimum two sites.
With 2019 release 3 of Spectralink IP-DECT Server firmware (PCS 19C_) zone based
paging has been implemented and must be used on sites where multicast signaling or
site based paging alone is not enough.
From 2019 release 3 you must select relevant paging method before continuing with the
base station configuration, and site based paging is not automatically used when min-
imum two sites are configured. If Multicast signaling is supported, this is the preferred
method.
For more information, see "Spectralink IP-DECT Base Station Configuration Methods -
Considerations" on page158.
Spectralink IP-DECT Server 200/400/6500 and Virtual IP-DECT Server One Installation and Configuration Guide