Field Setting
Standby text (Optional) Standby text is a fixed label shown in the top left
part of the screen on the DECT handset when in
idle state.
Note: Disallowed characters: <>\"
Note: This feature is only available if Spectralink
DECT handsets are being used. If third party
DECT handsets are being subscribed, this fea-
ture is not supported.
Disabled (Optional) If enabled, the user is disabled.
Note: A disabled user cannot make calls from
the handset.
SIP
SIP Username (Optional) (Only on Spec-
tralink DECT Server)
If not defined, then the SIP Username is auto-
matically set to Local Number.
Username/Extension (Only on Spec-
tralink IP-DECT/Virtual IP-DECT
Server)
The actual directory number of the handset
defined in the Cisco Unified CM.
Note: Allowed characters: a-z, A-Z, 0-9, -_.!~*'
()&=+$,;?/
Note: This field must be unique within the Spec-
tralink IP-DECT Server. If simultaneous ring on
two or more handsets is required, a Cisco Uni-
fied CM ring group must be set up.
Secondary username (Optional) (Only
on Spectralink IP-DECT/Virtual IP-
DECT Server)
If defined, the Secondary username can be
used to make voice calls in case the connection
to the SIP PBX is lost. The Secondary user-
name must be globally unique.
Note: Allowed characters: a-z, A-Z, 0-9, -_.!~*'
()&=+$,;?/
In some PBXs there is a mapping between user-
name and number (e.g. Username = hz2539jk,
Number = 1234). If the connection to the SIP
PBX is lost, then it is possible to make the map-
ping internally by defining a Secondary user-
name.
Note: The feature MUST be used with SIP set-
ting Allow internal routing fallback enabled.
For more information, see"SIP Settings" on
page9.
To Next Page
Loading...
