SpectraLink IP-DECT SERVER 6500 - System Architecture and Network; Approvals and Environment

14205603-IG, Edition 11.0
May 2020, Original document
15
Adding Users and Handsets
Each individual DECT user/handset must be added to the Spectralink IP-DECT/DECT/Virtual IP-
DECT Server and later on to the Cisco Unified Communications Manager.
This section describes how to add the handsets to the Spectralink IP-DECT/DECT/Virtual IP-DECT
Server.
To Add Users to the Spectralink IP-DECT/DECT/Virtual IP-DECT Server from the
Web Based Administration Page
1. If using Spectralink IP-DECT 200/400/6500 and Spectralink Virtual IP-DECT Server One,
click Users, click List Users, and then click New.
If using Spectralink DECT 2500/8000, click Users, click Overview, and then click New.
2. Enter the required information:
Field Setting
Interface (only Spectralink DECT Server 2500/8000)
Line type Select SIP.
DECT device
IPEI (Optional) If a specific handset is being subscribed for this
extension, enter the IPEI number of the actual
handset. (The IPEI number is readable from the
label on the product). If this is not the case this
field can be left empty and it will auto-fill when
the handsets subscribe.
Note: A SIP REGISTER will not be sent before
there is an IPEI number present.
Access code (Optional) Administrators can define a system wide or indi-
vidual access code as extra wireless security
during the subscription process.
Note: Some 3rd party phones may need an
Access code to register to the Spectralink IP-
DECT/DECT/Virtual IP-DECT Server.
Configuration group (Optional) (Only on
Spectralink IP-DECT/Virtual IP-DECT
Server)
If using handset configuration, enter the Group
ID of the Configuration Group.
User
Local Number (DN) (Only Spectralink
DECT Server)
The local number (DN) is required on Spec-
tralink DECT Server 2500/8000.
Spectralink IP-DECT Server 200/400/6500, Virtual IP-DECT Server One and DECT Server 2500/8000 Interoperability Guide