14205603-IG, Edition 11.0
May 2020, Original document
9
Spectralink IP-DECT/DECT/Virtual IP-
DECT Server
Below is a description of how to configure the Spectralink IP-DECT/DECT/Virtual IP-DECT Server
and how to add users and handsets to the system.
Configuring the Spectralink IP-DECT/DECT/Virtual IP-
DECT Server
General Settings
1. Click Configuration, the General Configuration page displays.
2. Check that the Hostname (FQDN) field is left blank under DNS settings when connected to
the Cisco Unified Server.
3. Click Save, and then reboot the system.
SIP Settings
The Spectralink IP-DECT/DECT/Virtual IP-DECT Server requires a few SIP settings to be adjusted
in order to connect properly to the Cisco Unified Server.
Note:
SIP settings not mentioned below should be left at their default values.
Spectralink IP-DECT Server 200/400/6500, Virtual IP-DECT Server One and DECT Server 2500/8000 Interoperability Guide
To Next Page
Loading...
