OPTIONAL
Program Remote
to Control Your TV
A Turn on the device (TV, DVD player, etc.) that you want to control with the remote.
B On the remote, press and hold the button that corresponds with your device
and the OK/SEL buttons for three seconds. An LED light will turn on to indicate
that the device is ready to be programmed.
C Within 30 seconds, point the remote at the device, and then press the
CH+ or CH- button.
D Continue pressing the CH+ or CH- button until the device turns o. Check if the
remote has been programmed successfully by pressing the POWER button to
turn on your device.
E Press the corresponding device button to complete programming your remote.
An LED light will blink twice to confirm programming is complete.
Note: If the remote is unable to control your device after following these steps,
visit spectrum.net/click for additional instructions.
Have Questions?
We’re here to help. To learn more about your services,
visit spectrum.net/support
Didn’t find what you’re looking for? Call us at (855) 632-7020.
RETURNING EQUIPMENT?
To avoid additional charges,
visit spectrum.net/equipment-return to view your options.
To Previous Page
Loading...
Need help?
General
