System Information Page
When you enter system information setting, system key information can be viewed in this page.
In ‘Total Regenerations: ‘Total Treated Water’and ‘Peak Flow Rate’
page, pressing and holding the ‘CONFIRM’ button for 3 seconds will
reset the value to zero.
NOTE
Operation During a Power Failure
In the event of a power failure, the valve will keep track of the time and day. The programmed settings
are stored in a non-volatile memory and will not be lost during a power failure. If power fails while the
unit is in regeneration, the valve will nish regeneration from the point it is at once power is restored. If
the valve misses a scheduled regeneration due to a power failure, it will queue a regeneration at the next
regeneration time once power is restored.
To Next Page
Loading...