English-03
Note
The installation position of equipment and brackets should not block
the driver's sight and affect driving safety.
2.3 Suction Bracket Installation
1.Align the suction bracket clips with the holes on the back of
the device and push them up to secure the bracket.
2.Thoroughly clean and dry the car dashboard surface, remove
dust or debris, and make sure the surface is flat.
3.Remove the 3M adhesive release paper from the dashboard
pad mounting disk and adhere it to a clean instrument panel
surface.
4.Allow to sit for 3 hours or more to ensure a strong bond. Then
remove the protective film from the dashboard pad.
5.Tear off the protective film from the suction bracket, place the
suction cups firmly in the center of the dashboard pad mount-
ing disk, and press the lock button.
6.Adjust the angle of the device screen.
2.4 TF Card Installation（Optional）
· Insert the TF card into the TF card slot.
· The self-provided TF card should meet the following require
ments: Class 10 or above, the capacity does not exceed 128GB.
To Next Page
Loading...
