© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
38899
12
3. Add clothes loosely into the washtub.
Figure 8
4. Close the lid. The washer will not agitate or spin
with the lid open.
Figure 9
5. Set WASH/RINSE temperatures.
NOTE: The washer will provide a cold rinse in all
TEMPERATURE settings. Cold rinses will save
you money and energy and will help reduce
wrinkling in permanent press and synthetics.
NOTE: The Energy Saver settings, marked with a
dot (•), show which temperature settings will use
the least energy.
6. Set LOAD SIZE (WATER LEVEL) control. Use
RESET if agitation has started and more water is
needed.
IMPORTANT: Holding the LOAD SIZE (WATER
LEVEL) control in the RESET position can cause
flooding of the washer.
7. Select the cycle according to the type of fabric
being washed. Push the timer knob in and turn
clockwise to the desired cycle and wash time.
8. Pull the timer knob out to start the water fill.
Agitation will begin when the water reaches the
level you selected.
The washer will stop (pause) shortly before the
wash and rinse spins. Do not turn the timer
through these pauses. They are part of the cycle.
Timer
Although the washer cycles are automatic, the timer
may be reset to lengthen, shorten or repeat a portion of
a cycle.
To set or reset the timer, push timer knob in to stop the
washer. Hold timer knob in firmly while turning it
clockwise to the setting desired. Pull timer knob out to
start the washer.
Soaking
Set the timer knob in the center of the word “RINSE”
(this prevents the washer from spinning without first
filling with water). Place the soaking product and
clothes load in the washtub. Pull timer knob to start
washer fill. After fill is completed and agitation has
started, push the timer knob in. This will stop the
washer. When the clothes have soaked the desired
length of time, TURN THE TIMER KNOB TO THE
END OF THE RINSE SETTING, then pull the timer
knob out to start the spin.
W281I
W318I
W281I
CAUTION
Failure to turn the timer knob to the spin
cycle and completely draining the washtub
after soaking will result in the washer
overflowing and causing property damage.
W256
To Next Page
Loading...
Need help?
General
