© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Maintenance
38899
14
Reinstallation of Shipping Materials
Shipping Brace
The shipping brace in the lid opening should be saved
and reinstalled whenever the washer is moved. To
reinstall the brace, open the washer lid and place the
brace over the washer agitator, placing the back of the
brace into the washtub first.
Shipping Plug
The plastic shipping plug should be saved and
reinstalled any time the washer is moved. The plug fits
into two openings: the base opening and the shipping
plug opening on the bottom of the mobile pivot dome.
The plug MUST be inserted into both openings to
prevent damage to the washer. In order to accomplish
this, the shipping plug opening must be directly lined
up with the base opening. Refer to Figure 10.
Figure 10
Motor Overload Protector
This internal overload protector will stop the motor
automatically in the event of an overload. The
overload protector will reset itself in two or three
minutes and the motor will restart automatically. If the
overload protector stops the motor again, remove the
washer from use and call the service person to correct
the problem.
TLW544N
1 Shipping Plug Opening
2 Base Opening
3 Shipping Plug
1
2
3
To Next Page
Loading...
Need help?
General
