Need help?Do you have a question about the SpeedFun FURIOUS EVO and is the answer not in the manual?
Remove the crank arm and its securing screw using the specific ISIS pin extractor tool.
Remove the screws securing the plastic side cover of the motor unit.
Remove the screws that attach the under-motor protection plate.
Remove the chain and chainring using a sector wrench, unscrewing clockwise.
Unscrew the motor mounting screws, three on each side (right and left).
Gently pull the motor down, being careful not to tear wires, and hang it for access.
Open the speed sensor connector (green arrow) and connect Furious connectors.
Cut and strip the end of the red wire connected to the lights (red arrow).
Cut and strip the end of the Yellow Furious wire.
Connect the red wire to the yellow wire, solder, and insulate with heat shrink tubing.
Obtain speed release by pressing the Light button; the 'LIGHT' symbol appears on display.
Deactivate the Automatic Lights function ('A') to prevent discontinuous speed release.
Manipulates rear wheel speed to achieve high real speed with active motor below 25 km/h.
Connects between speed sensor and motor; activated by pedaling hard with longest gear.
Connects between sensor, motor, and lights output; activated/deactivated via e-bike lights.
Activated/deactivated by cycling power; involves raising rear wheel and pedaling.
Transform to EASY Vers. by cutting and insulating the white wire from the device.
Strongly recommended to use a protective helmet due to increased achievable speeds.
E-bike exceeding 25 km/h is treated as a moped, requiring registration, tax, insurance, and license.
Manufacturer disclaims responsibility for damage and notes modifications void warranty.
General| Speed Limit Removal | Yes |
|---|---|
| Real Speed Display | Yes |
| App Connectivity | Yes |
| Bluetooth | Yes |
| Configuration via App | Yes |
To Next Page
