SpeedyBee F405 Mini BLS - ESC Firmware Update

ESC Firmware Update
13/14
This 8-bit 50A ESC can run BLHeliS or Bluejay firmware. It is loaded with BLHeliS firmware by default.
You could also flash it to Bluejay firmware which can support RPM filtering and Bi-directional Dhsot.
Firmware flashing steps are as follows:
● Remove all the propellers from your drone.
● Ensure that the flight controller is connected properly to the ESC, then power up the drone. This
step ensures that the ESC starts up correctly.
● Connect the flight controller to the computer using a USB Type-C cable.
● Open the Chrome browser and visit the following website: https://www.esc-congurator.com/
● Follow the firmware flashing steps as shown in the screenshots below.
Impoant note:
On the 6th inteace, the "ESC" type must be selected as "J-H-40".
4
5
6
1
2
3
0
0
J-H-40