EN
7
Forward Programming
Verify your transmitter is updated your transmitter to the latest Spektrum Air-
Ware™ software to take advantage of Forward Programming. See your trans-
mitter manual for updating instructions.
In your transmitter menu select Forward Programming -> Settings ->
• Select Failsafe -> Select each channel and assign it to Preset or Hold
Last. When you select a different channel for Output, a new group of
settings appears.
Capture Failsafe Postions ->
Hold the control sticks in the desired failsafe positions and select Apply.
Channel selections must be individually set in Forward Programming to
apply the preset positions or each channel will default to Hold Last. The
value captured will be reflected in the position shown for each channel.
• Initiate Receiver Bind Mode
Gives you the option of putting the receiver into Bind Mode from this menu.
Preset Failsafe
With preset failsafe, you can set the specific control surface positions you want
to use if the signal is lost. When the receiver detects the signal from the trans-
mitter, normal aircraft operation resumes.
Only available through Forward Programming
Testing Failsafe
Secure the aircraft on the ground and remove the propeller. Test Failsafe set-
tings by turning the transmitter RF output off and noting how the receiver drives
the control surfaces.
Receiver Power Only
• If the receiver is turned when no transmitter signal is present, the throttle
channel will not have a control signal to avoid operating or arming the
electronic speed control.
• All other channels have no output until the receiver has linked to the
transmitter.
To Next Page
Loading...
Need help?
General
