24 SPEKTRUM DX3R PROGRAMMING GUIDE
fraMe raTe
User Name
01: Model 01
Fr am e Ra te
Fram e r a t e:
11ms
CAUTION:
Digi t a l serv o s
must b e used
with 5 . 5 ms
≤
To allow the DX3R to be compatible with all types
of servos (older analogs through the latest high
response rate digitals), three frame rates are
available.
5.5ms: Gives the fastest response rate,
however, is only compatible with
high performance digital servos.
11ms: Offer good response rates and is
compatible with most digital and
analog servos (this is the default
position).
16.5ms: This is the least responsive rate and
is needed for older analog servos.
Note: It’s always recommended that the fastest
response rate that the servos can handle be
used, as this gives the lowest latency/ fastest
response. If the frame rate is incompatible
with the servo, the servo will move erratically
or in some cases not at all. If this occurs, it’s
necessary to change the frame rate to the next
highest value.
To aCCess The
fraMe raTe funCTIon:
In the List screen, use the roller to highlight the
Frame Rate function.
Press the roller to access the Frame Rate function.
The above screen will appear.
Use the roller to select and highlight Frame Rate: at
the bottom of the screen.
Press the roller to highlight the Frame Rate: function
and the surrounding box will flash; then rotate the
roller to select the frame rate.
To return to the Main screen, press and hold the
roller for more than three seconds.
To Next Page
Loading...
Need help?
General
