14
SPEKTRUM DX6C • TRANSMITTER INSTRUCTION MANUAL
EN
MENU
SYSTEM SETTINGS
System settings allow adjustments to the following transmitter settings:
User Name
The User Name field displays the user name above the model name on the main screen.
1. Slide to the desired letter position and click the scroll wheel once. A flashing box appears.
2. Slide Up or Down until the desired character appears. Press OK once to save the character.
3. Slide to the next desired letter position. Repeat Steps 1 and 2 until the Model Name is complete.
Language:
Change the transmitter’s language. The transmitter will retain the language for models already created.
New models will be created using the currently selected language.
• Display
• Trims
• Sounds
• About
• Calibrate
• Battery
Inactive Alarm:
An alarm activates if the transmitter sees a period of inactivity for a certain amount of time. The alarm is
helpful in reminding you to power off the transmitter and avoiding a situation where the transmitter battery
completely discharges.
• Inh (No alarm sounds)
• 5 min
• 10 min (Default)
• 30 min
• 60 min
Trims
Assign Trims to any trimmer or switch on the transmitter.
1. Select the Trim position from the list.
2. Press OK to select the position.
3. Slide to select the Trim desired in that position.
4. Press OK to save the selection.
Display
Contrast
To adjust the screen contrast:
1. Slide to Contrast and click the scroll wheel.
2. Slide Up or Down to adjust the contrast value. Lower numbers lighten the contrast, higher numbers
darken it.
3. Press OK once to save the selection.
Duration
On-time (“Duration”) has values Off, On, 3s, 10s, 20s, 30s, 45s, and 60s (in that order), and defaults to 30s.
On and Off hold the backlight in that state, whereas the others will turn the backlight off after a period of
time since the last user input.
Brightness
Values in the range 5% to 100% in 5% steps, and defaults to 100%.
To Next Page
Loading...
Need help?
General