21
SPEKTRUM DX6 • TRANSMITTER INSTRUCTION MANUAL
EN
WARRANTY AND SERVICE CONTACT INFORMATION
Country of
Purchase
Horizon Hobby Contact Information Address
United States of
America
Horizon Service Center
(Repairs and Repair Requests)
servicecenter.horizonhobby.com/
RequestForm/
2904 Research Road
Champaign, Illinois, 61822 USA
Horizon Product Support
(Product Technical Assistance)
productsupport@horizonhobby.com
877-504-0233
Sales
websales@horizonhobby.com
800-338-4639
EU
Horizon Technischer Service service@horizonhobby.eu
Hanskampring 9
D 22885 Barsbüttel, Germany
Sales: Horizon Hobby GmbH +49 (0) 4121 2655 100
SPMR6125 Trasmitter only: Contains FCC ID: BRWPLANO1T
SPM6125 Transmitter and SR315 Receiver:
SPMR6125: Contains FCC ID: BRWPLANO1T
SR315 - FCC ID: BRWSRIRVINGV1
FCC INFORMATION
This equipment complies with FCC and IC radiation exposure
limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm
between the radiator and/or antenna and your body (excluding
fingers, hands, wrists, ankles and feet). This transmitter must not
be co-located or operating in conjunction with any other antenna
or transmitter.transmitter.
Supplier’s Declaration of Conformity
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Horizon Hobby, LLC
2904 Research Rd.,
Champaigvn, IL 61822
Email: compliance@horizonhobby.com
Web: HorizonHobby.com
To Next Page
Loading...
Need help?
General