Differential
UP Aileron is set to move more by proportion to the Down Aileron on the other side.
Set to On and vary the % to get the amount of Differential you need to avoid asymmetric Aileron
behaviour.
Camber Presets
Flight modes are pretty subjective. Some models have different preference. Different settings are used
on different models and you take time trimming these settings out on the field. In general, the starting
settings on this particular model are:
Launch mode - Reflex -1.5mm, elevator -0.75mm
Cruise mode - Camber 0mm, elevator 0mm
Thermal mode - Camber +2.5mm, elevator +1mm
Flight modes settings can be done in the "Camber Presets" page. Initial settings are shown in the photo
below. Do note that the Elev % numbers are adjusted at the field.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
