SPERONI CAM 85 CR - User Manual

Questions and Answers

N
Nicole BowenAug 8, 2025
What to do if my SPERONI CAM 85 CR Water Pump motor will not start?
- R
  Rachel DavisAug 8, 2025
  If your SPERONI Water Pump's motor won't start, first, check if there is mains voltage. If voltage is present, the pump impeller might be jammed or the thermostat detached. In such cases, dismantle the hydraulic section to check if the impeller rotates freely, then carefully reassemble it.
D
davidwoodAug 14, 2025
Why SPERONI CAM 85 CR Water Pump will not suck?
- C
  Collin HurleyAug 14, 2025
  If your SPERONI Water Pump isn't sucking water, ensure the suction valve is submerged at least 30 cm in water. Also, check if the pump chamber has water; if not, pour water into the suction union. Air in the suction pipe, a non-airtight suction valve, or a dirty suction rose can also be causes. Clean these parts as needed and verify that the maximum suction lift hasn't been exceeded.
J
Jacob SnowAug 22, 2025
How to fix insufficient rate of flow in SPERONI CAM 85 CR?
- M
  Melissa AndersonAug 23, 2025
  If your SPERONI Water Pump has an insufficient rate of flow, check that the suction lift isn't too high and that the suction rose is clean. If the water level is dropping quickly, lower the suction valve. Foreign bodies might also be reducing the pump's flow rate, so clean the pump and replace any worn parts.
R
rachelholdenAug 30, 2025
What to do if thermal cutout switches off SPERONI CAM 85 CR Water Pump?
- M
  Mr. Jacob SanchezAug 30, 2025
  If the thermal cutout switches off your SPERONI Water Pump, it's likely due to motor overload or excessive friction caused by foreign bodies. In both cases, eliminate any foreign bodies that may be causing the issue.