What to do if SPERONI CAM 80/22 connects with very low water intake?
If your SPERONI Water Pump connects with very low water intake, it could be due to low pressure in the delivery tank's air cushion. Increase the pressure of the air cushion in the filling valve to 1.5 bar.
What to do if my SPERONI CAM 80/22 will not suck?
If your SPERONI Water Pump isn't sucking water, several issues could be the cause. First, ensure the suction valve is submerged in water, at least 30 cm deep. Next, check that the pump chamber is filled with water; if not, pour water into the suction union. Inspect the suction pipe for any air leaks and ensure it's properly sealed. Also, the suction valve should be airtight, so clean it to ensure a proper seal. Clear any clogs from the suction rose. Finally, verify that the maximum suction height hasn't been exceeded.
Why does my SPERONI CAM 80/22 have an insufficient rate of flow?
An insufficient flow rate in your SPERONI Water Pump can stem from several causes. Check if the suction height is too high. Also, a dirty suction rose can restrict flow, so clean it thoroughly. If the water level is dropping quickly, try setting the suction valve lower down. Foreign bodies might be reducing the pump's flow rate, so clean the pump and replace any worn parts.
How to troubleshoot a SPERONI CAM 80/22 motor that will not start?
If your SPERONI Water Pump motor isn't starting, begin by checking if there's mains voltage present. If there is no voltage, check the voltage. Another possible reason is a jammed pump impeller, so dismantle the pump and clean it. Also, check for a detached thermostat, and if found, dismantle the pump and clean it.
General recommendations for operating the pressure tank unit.
Guidance on fitting the suction pipe for optimal pump performance.
Instructions for setting up the delivery piping for proper air expulsion.
Allows adjustment of pump's connection and cut-off pressure settings for optimal operation.
General| Pump type | Centrifugal |
|---|---|
| Liquid type | Clean water |
| Maximum head | 22 m |
| Power | 0.37 kW |
| Voltage | 230 V |
| Inlet connection | 1 inch |
| Outlet connection | 1 inch |
| Frequency | 50 Hz |
| Inlet Diameter | 1 inch |
| Outlet Diameter | 1 inch |
| Phase | Single phase |
To Next Page
