How to fix insufficient flow rate in my SPERONI KS 801 Water Pump?
If your SPERONI Water Pump has an insufficient flow rate, consider the following: * Check that the suction lift isn't too high. * Clean the suction rose if it's dirty. * Lower the suction valve if the water level is falling quickly. * Clean the pump to remove any foreign bodies and replace any worn parts that may be reducing the flow rate.
What to do if my SPERONI Water Pump motor will not start?
If your SPERONI Water Pump's motor won't start, first, check if there is mains voltage. If voltage is present, the pump impeller might be jammed or the thermostat detached. In such cases, dismantle the hydraulic section to check if the impeller rotates freely, then carefully reassemble it.
Why SPERONI KS 801 will not suck?
If your SPERONI Water Pump isn't sucking water, ensure the suction valve is submerged at least 30 cm in water. Also, check if the pump chamber has water; if not, pour water into the suction union. Air in the suction pipe, a non-airtight suction valve, or a dirty suction rose can also be causes. Clean these parts as needed and verify that the maximum suction lift hasn't been exceeded.
How to fix insufficient rate of flow in SPERONI KS 801?
If your SPERONI Water Pump has an insufficient rate of flow, check that the suction lift isn't too high and that the suction rose is clean. If the water level is dropping quickly, lower the suction valve. Foreign bodies might also be reducing the pump's flow rate, so clean the pump and replace any worn parts.
What to do if thermal cutout switches off SPERONI KS 801 Water Pump?
If the thermal cutout switches off your SPERONI Water Pump, it's likely due to motor overload or excessive friction caused by foreign bodies. In both cases, eliminate any foreign bodies that may be causing the issue.
What to do if my SPERONI KS 801 Water Pump won't suck?
If your SPERONI Water Pump isn't sucking, here's what you can check: * Ensure the suction valve is submerged in water, at least 30 cm deep. * Pour water into the suction union to prime the pump chamber. * Inspect the suction pipe for any air leaks. * Clean the suction valve to ensure it's airtight. * Clean the suction rose if it's dirty. * Verify that the maximum suction lift hasn't been exceeded.
Why won't my SPERONI KS 801 Water Pump motor start?
If the motor of your SPERONI Water Pump won't start, consider these possible causes: * **No mains voltage:** Check the voltage supply. * **Pump impeller jammed:** Dismantle the hydraulic section to inspect the impeller, ensure it rotates freely, and reassemble carefully. * **Thermostat detached:** Dismantle the hydraulic section to inspect the impeller, ensure it rotates freely, and reassemble carefully.
Read operating instructions, ensure proper electrical connection, avoid unsafe operations.
Covers electrical safety, liquid limits, resistance, and intended use.
For irrigation, drawing water from ponds/wells, and pumping clear water only.
Fit suction pipe upwards, ensure airtightness, and open delivery parts for air expulsion.
Self-priming pump must be filled with delivery liquid until it overflows.
Pump is maintenance-free. Rinse if blocked, empty if frost risk.
General| Maximum immersion depth | 5 m |
|---|---|
| Power | 0.37 kW |
| Maximum head | 8 m |
| Weight | 5.9 kg |
| Max Head | 8 m |
| Frequency | 50 Hz |
| Type | Submersible |
| Max Flow Rate | 150 l/min |
To Next Page
