Using a marker, make a little
mark on the side of the hose
connecting to the top cone.
This way you will reassemble
the right hose to the right
component
To release the pinch, simply
hold both sides on the pinch
and pull gently. This will
release it.
You will see three wheels in the
pump; two of these wheels are
pinching the hose. Gently pull the
hose from one end until you see the
pinch. If you are pulling more than
1” (2cm) and can’t see the pinch, it is
on the other side. Pull the hose from
the other side and locate the pinch.
Disconnect the top and bottom
silicon hose from the stainless
tips
23
CEDARLANECULINARY.COM
SPHERIFICATOR DISASSEMBLY
DISASSEMBLING YOUR SPHERIFICATOR
To Next Page
Loading...