SPIDO COMBO-S2 - Technical Data; Mounting Instructions

EN
3. TECHNICAL DATA
4. MOUNTING INSTRUCTIONS
Carefully remove the product and ail
component parts from the box. Cross
reference ail parts in the box with
the parts list reference chart to make
certain ail parts are present before
beginning assembly. NOTE: Sorne
parts may be located within the lter
tank. To access these parts you must
remove the tank cover.
COMBO-S2 COMBO-4 COMBO-6 COMBO-10
FlowVolume(m
3
/h-bar) 3,2-0,4 4-0,4 6-0,4 10-0,4
MAXOperatingPressure(bar) 1,5 1,5 1,5 1,5
Filtration Area (m
2
) 0,13 0,13 0,13 0,13
RatedVoltage(VAC/Hz) 230 / 50 230 / 50 230 / 50 230 / 50
Power(Watts) 200 200 450 600
Protection Class (I.P.) X5 X5 X5 X5
Max.ambienttemperature(°C) 35 35 35 35
AqualoonVolume(g) 445 445 445 925
SandVolume(Kg) 16 16 16 33
2.50 m
min.
Instalthisproductwithasufcient
safetymarginfromthepool
parts are in the box. If you purchased
this product on or der and the product
was shipped to you, ensure that
delivery is complete. Damage to
product as a result of shipping is not the
re sponsibility of the supplier and must
be immediately reported to the shipper.
The shipper assumes the liability for
damages during deliv ery, the supplier is
not responsible for it.
PARTS INTO
THE TANK