EasyManua.ls Logo

Spin Master Hyper Actives Stunt - User Manual

Spin Master Hyper Actives Stunt
2 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
TM
C
ontents:
•
1 x Hyper Actives Stunt™
•
1 x Controller/Charger
•
1 x Instruction Guide
®
1. Open the battery door with a
screwdriver (not included).
2. If used batteries are
present, remove these
batteries from the unit by
pulling up on one end of
each battery.
3. Install new batteries as
shown in the polarity
diagram (+/-) inside the
battery compartment.
4
. Replace battery door
s
ecurely.
5. Check your local laws
and regulations for correct
recycling and/or battery
disposal.
INSTALLING/REPLACING THE BATTERIES
HOW TO CHARGE YOUR HYPER ACTIVES STUNT™
USING THE CONTROLLER/CHARGER
Battery
Compartment
Cover
Battery
Compartment
6 x
1.5V AA
Alkaline
Batteries
•
Controller/charger requires
6
x 1.5V AA alkaline
b
atteries (not included).
• Batteries are small objects.
•
Replacement of batteries
m
ust be done by adults.
•
Follow the polarity (+/-)
d
iagram in the battery
c
ompartment.
•
Promptly remove dead
b
atteries from the toy.
• Dispose of used batteries
properly.
•
Remove batteries for
p
rolonged storage.
•
Only batteries of the same
o
r equivalent type as re-
c
ommended are to be used.
• DO NOT incinerate used
b
atteries.
• DO NOT dispose of
batteries in fire, as batteries
may explode or leak.
•
DO NOT mix old and new
b
atteries.
•
DO NOT mix different types
o
f batteries, i.e.: alkaline/
s
tandard (carbon-zinc) or
r
echargeable batteries.
•
DO NOT use rechargeable
b
atteries.
• DO NOT recharge
non-rechargeable batteries.
•
DO NOT short-circuit the
s
upply terminals.
•
DO NOT store your car
o
r controller near heat or in
d
irect sunlight.
BATTERY SAFETY INFORMATION
Left/Right
8-10YRS
O
CHG OFF ON
CHG OFF ON
1. Turn vehicle OFF.
2. Turn controller/charger OFF.
3. Open charge door to access
charge cable.
4. Open charge port cover located
on the side of the vehicle.
5. Carefully push the charge plug
all the way into the vehicle’s
charge port.
6. Set the controller/charger switch
to CHG.
7. The red charging light will turn
on and charging will begin when
it starts to flash. After 30 to 50
minutes the charging will be
complete and the red charge
light and green power light will
both start to flash.
8. When charging is complete,
turn controller/charger OFF.
9. Carefully remove the
charge plug from the vehicle’s
charge port.
10. Close the charge port cover.
11. Wrap charge cable starting
at tab indicated then close
charge door.
CHG OFF ON
1
4
8 9 10 11
5 6 7
2 3
INSTRUCTIONS
Controller/Charger
Hyper Actives
Stunt™
F
orward/
R
everse
P
ower Light
C
harge Light
C
HG/OFF/ON
S
witch
S
pin Button
Turbo Button
C
over and
C
harge Cable
I
mpact
B
umper
Charge
Port
ON/OFF
Switch
O
ver-sized
T
ires
Forward/Reverse, Left/Right
1. Turn vehicle ON.
2. Turn controller/charger ON.
3. The left stick controls
the vehicle’s forward and
reverse driving.
4. To move the vehicle to the right
push the right stick to the right.
5. To move the vehicle to the left
move the right stick to the left.
4 5
1
CHG OFF ON
2 3
T
rim Knob
NOTE: 1. If the charge light and power light are flashing alternatively while
charging, there may be a bad cable connection. Check that cable and plug
are connected correctly and repeat charging steps 1 to 6.
2. The remote control will automatically shut off after idling for about
5 minutes. To reactivate turn off and on.
3. When the remote control is in either ON status or CHARGE status and
the green power light is flashing, it means that the battery level is low
and the batteries need to be replaced.
WARNING:
CHOKING HAZARD – Small parts.
Not for Children under 3 years.

Questions and Answers

  • M
    michelle50Aug 11, 2025
    What to do if my Spin Master Toy vehicle is not responding or driving on its own?
    • S
      Steven ScottAug 11, 2025
      If your Spin Master Toy vehicle isn't responding or is driving on its own, here's what to check: * Ensure you are only using the controller/charger supplied with the vehicle. * Avoid operating the vehicle near devices that emit other infrared signals. * Bright lights may be affecting the IR control. Try driving in a different location away from windows or bright lights.
  • C
    craigvanessaAug 19, 2025
    How to clean my dirty Spin Master Toy vehicle and/or controller?
    • R
      romerojasonAug 20, 2025
      To clean your dirty Spin Master Toy vehicle and/or controller: 1. Ensure both the controller and vehicle are turned off. 2. Have an adult remove the batteries first and replace the battery cover. 3. Slightly dampen a clean cloth with water and wipe the toy clean. 4. Wipe it dry. Important: Do not immerse the toy in water or use any chemicals. Allow the toy to completely dry before reinserting the batteries into the clean, dry battery compartment. The issue may be caused by inappropriate driving surface or dirty hands.
  • K
    kbrownOct 31, 2025
    Why is my Spin Master Toy vehicle so slow or not moving?
    • J
      John StewartOct 31, 2025
      Your Spin Master Toy vehicle might be slow or not moving due to several reasons: 1. The controller batteries might be low. If the green power light is flashing, replace them with fresh batteries. 2. The vehicle could be out of the controller's range, so move closer. 3. Hair or debris might be stuck in the wheels or axles. Turn off both the vehicle and controller, and have an adult carefully remove any obstructions. 4. The batteries might be installed incorrectly. Ensure an adult checks the correct battery installation in the controller with the vehicle and controller turned off. 5. The surface may not be suitable. This toy is designed for indoor play on hard surfaces like non-carpeted, flat tile, or wooden floors. Avoid thick carpet, grass, or sand. 6. The controller might not be ai...

Summary

Installing and Replacing Batteries

Battery Safety Information

Covers essential safety guidelines for using and handling batteries in the toy and controller.

How to Charge Your Hyper Actives Stunt

Using the Controller;Charger

Vehicle Trim Adjustment

Turbo Acceleration

Details how to activate the turbo button for increased vehicle speed.

Performing Spins

Explains how to make the vehicle perform spins using the spin button.

Once Youre Finished Playing

Troubleshooting Guide

Product Battery Safety and Disposal

Spin Master Hyper Actives Stunt Specifications

General IconGeneral
BrandSpin Master
ModelHyper Actives Stunt
CategoryToy
LanguageEnglish

Related product manuals