30 Spinel S.r.l.
POD HOLDER ADJUSTMENT
SPINEL S.r.l. carries out a correct adjustment of the upper and lower pod holders during quality
tests.
In case of leaking during coffee delivery from the junction part of the two pod holders, it will be
necessary to adjust it manually by proceeding as follows:
ATTENZIONE: do the registration and replacement pod holder only and exclusively the
machine is cold.
Take the pod holders in open position, move the coffee spout, slightly release the nut positioned on
the lower pod holder plate, behind the spout.
Insert the Allen key (size No. 5) into the hole underneath the lower pod holder plate.
- by turning to the left, the tightening strength is increased;
- by turning to the right, the tightening strength is reduced.
Once having carried out the adjustment procedures, tighten the locking nut of the lower pod holder
and re-position the coffee spout.
If the leak is not repaired through the pod holder adjustment, inspect the upper gasket and replace
it, if necessary. However, these operations should be carried out by authorized personnel, using
original SPINEL s.r.l. spare parts.
SPARE PARTS
Replace components only with ORIGINAL SPINEL S.r.l. SPARE PARTS, available in all Spinel
service centers. SPINEL S.r.l. accepts no liability for failures of machines type JESSICA if spare
parts supplied by others are employed. All repairs should be carried out only in our service centers
and/or by authorized qualified staff only.
GUARANTEE
The guarantee has a validity of 12 months from the machine dispatch date from SPINEL S.r.l.
warehouse.
:
Spinel S.r.l. does not acknowledge any failure due to a lack of routine
maintenance of water softener according to procedures hereby described.
To Next Page
Loading...
