5
Note:
When the device is inated with carbon dioxide (CO2) it can permeate the bladder
more quickly than when inated with air. A reduction in bladder pressure will occur over
several hours therefore it must be topped up by means of the oral tube.
WARNING: Do not fully inate the device orally and then activate the CO2
cylinder. The resulting overpressure could seriously damage the device
resulting in loss of otation.
WARNING:
If in doubt, send your Alto to your nearest service center for evaluation and/
or servicing.
If you are not completely condent about undertaking the self-inspection
and servicing in accordance with these instructions, you must not use your
device again until it has been professionally inspected and serviced.
(For details of your nearest service center see www.spinlockusa.com).
Any modication or repair to any part of the device is expressly forbidden
unless carried out by Spinlock Ltd.
REMEMBER: RE-ARM AND RE-PACK THE DEVICE IN ACCORDANCE WITH
THESE INSTRUCTIONS - See video at www.spinlockusa.com
The ALTO uses a 16g cylinder and requires re-arming kit DW-RAR/75
UNSCREW AND INSPECT THE THREADED END OF THE CO2 CYLINDER
TO CONFIRM IT IS UNUSED.
Cleaning, Maintenance, Storage
Remove gas cylinder and automatic components and then clean by hand and rinse in
clean fresh water (maximum temperature 86 F (30° C)). Dry in a cool, ventilated dark
room. Grease spots may be removed with trichlorethylene. Webbing shrinks very slightly
in drying. Though UV protected, this product is best stored away from direct light, in a well
ventilated place away from extreme temperatures.
To Next Page
Loading...
