SPINNER
®
ELITE OWNER’S MANUAL
www.spinning.com 800.847.SPIN (7746)
17
SPINNER
®
BIKE ASSEMBLY
STEP 1: UNPACK THE CARTON
Open the shipping carton and remove all of the parts. Make sure that
the following parts are included and that no damage has occurred
during shipping:
• Bike frame with flywheel
• Front stabilizer bar with
transportation wheels
• Rear stabilizer bar
• Handlebars
• Handlebar stem
• Pedals
• Pop pin assembly seat
• Seat slider and saddle
Take the time to enter your Spinner® bike serial number in the space
below (the serial number is located on the bottom crossbar). If parts
are missing or if you have any assembly questions, please contact
customer service at 888.704.SPIN (7746).
Serial No. : ____________________________________________
STEP 2: ATTACH THE STABILIZER BARS
Have someone help you tilt the bike forward
(toward the flywheel) and stabilize it. Remove
the rear plastic shipping guard. Then attach
the rear stabilizer bar from the underside with
the provided bolts and washers. Line up the
holes in the stabilizer bar with the holes in the
frame. Using the included wrench, tighten
the bolts (with washers) securely. Repeat the
process (now leaning the bike rearward) for
the with the front stabilizer bar.
STEP 3A: ASSEMBLE THE SEAT POST
1. Place the seat slider on top of the seat post,
making sure that the sliding threaded part
fits near the rear of the lower slot of the seat
post.
2. Place the large brass washer on the
threaded portion of the seat lever. Screw
the lever into the threaded slider several
rotations.
1
2
3A
• Seat post
• Owner’s manual
• Fore/aft adjusting lever seat
• Assembly card that includes all of the tools
and hardware needed to put your bike
together
• Tablet holder assembly.
• Left-side crank.
To Next Page
Loading...
