© 2021 Mad Dogg Athletics, Inc. All rights reserved.
20
STEP 6B: INSTALL THE PEDALS
Turn the resistance knob clockwise until the
crank arms are immobilized. Remove the
pedals from the packaging. Install the left
pedal on the left crank. Use the multi-wrench
supplied and turn counterclockwise to tighten.
Install the right pedal on the right crank. Use
the multi-wrench supplied and turn clockwise
to tighten. Remember, pedals are always
tightened by turning the wrench over the top
of the spindle towards the front of the bike.
Be sure both pedals are tightened securely.
STEP 7: LEVEL THE BIKE
Move the bike to a level location where it will
be used. Your Spinner Bike requires 1 meter
(39.4”) of unobstructed space all the way
around the perimeter. Rock the bike gently to
check for wobble. If needed, use the leveling
feet under the front and rear stabilizer bars
to steady the bike. Turn the leveling feet
counterclockwise to decrease the height or
clockwise to increase the height until the bike
is stable
7
6B
NOTE: The pedal spindles and cranks
are marked “L” (left) and “R” (right).
Left and right are referenced from a
seated position on the bike. Be sure
to install the pedals on the correct
side of the bike.
To Next Page
Loading...
