(Default setting)
The programs are selected as described in Table 7 below.
The input combinations on R0, R1, R2, decide the program that will run.
Note that when there are no inputs to these terminals, the program will halt.
Table 7 SX100e BMS program selection chart
(Note – this is different to the SX100. Also Prog 1 is not available in BMS mode on the SX100e )
Fig. 5 Digital inputs
)1cigol=1,0cigol=0('ltt'=stupnI )nepo=O,desolc=C('tnoc'=stupnI
0R1R2RgorP0R1R2RgorP
000 tlaH OOO tlaH
1002 COO2
0103 OCO3
1104 CCO4
0015 OOC5
10 16 COC6
0117 OCC7
1118 CCC8
To Next Page
Loading...
