Spirax Sarco SX100e - Running a Program

IM-S27-12 CH Issue 1 7
:edomesabmorfretneoT
sserP GORP dna PU )deyalpsidsiegassem'drowssaP'(rehtegot
esU PU ro NWOD edocytiruceS2leveLro1leveLrehtietcelesotnottub
sserP LLORCS nottub
noitpircseD
egasseM
yalpsid
egnareulaV
yrotcaF
gnittes
n
ielibaliavA
ytiruces
level
12
etairporppatceles-yltsriF(
GORPehtgnisserpybmargorp
deriuqerehtlitnunottub
sidetideebot.onmargorp
wodniwehtnideyalpsid
GRPdnaTESehtottnecajda
)s'del
2ot1
2ot1
=noitpotxEfi(
)'htob'ro'tuo'
8ot2
)'smb'=noitpotxEfi(
/NA seYseY
tnioPteStegraT PStegraT003ot0 °C56seYseY
emiTtratSmargorP tatratS95:32ot00:000.80seYseY
emiTdnEmargorP tadnE95:32ot00:000.71seYseY
syadnurmargorP
nuR
syaD
,seuT,noM,nuS
,taS,irF,uhT,deW
,)irF-noM(yd5
,)taS-noM(yd6
)keewasyaD7(LLA
yd5seYseY
noitcnufemitteS ?emiTteSoN,seY/NA seYseY
sujdAt/ gnitteSemiTkcehc emiT95:32-00:0/NA seYseY
sujdAt/ keewfoyadkcehc yaD
,seuT,noM,nuS
taS,irF,uhT,deW
/NA seYseY
tidErotarepOmorftixeoT
nottubEDOMsserPedoM
deriuqerehtlitnuyldetaeper
sserpneht,deyalpsidsiedom
nottubLLORCS
elddiM
-yalpsid
otoG
rewoL
-yalpsid
edoM
esaB,tidE,pO
,gorP.feD,lrtC.feD
/NA
seY
oN
seY
seY
ehtsserP:edoMtidErotarepOmorftixeoT EDOM edomderisedehtlitnuyldetaepernottub
sserpnehT'ESAB'.g.e,deyalpsidsiegassem LLORCS .
Table 3 SX100e Operator edit mode
4.3 Running a program
Program 1 (timed) - if the controller is set to run on the current day and time, the program
will start automatically once the controller has been switched on
(there may be a delay of up to a minute for this to happen after initial
power up)
Program 2 (constant) - having selected program 2, it is necessary to press the RUN/STOP
button once.