Spirax Sarco SX100e - Page 6

IM-S27-12 CH Issue 16
4. Selecting, defining, running
and stopping a program
:edomesabmorfretneoT
sserP GORP dna PU )deyalpsidsiegassem'drowssaP'(rehtegot
esU PU ro NWOD edocytiruceS2leveLro1leveLrehtietcelesotnottub
sserP LLORCS nottub
noitpircseD
egasseM
yalpsid
egnareulaV
yrotcaF
gnittes
n
ielibaliavA
ytiruces
level
12
ybmargorpetairporppatceleS
nottubGORPehtgnisserp
.onmargorpderiuqerehtlitnu
ehtnideyalpsidsidetideebot
TESehtottnecajdawodniw
)s'delGRPdna
2ot1
2ot1
=noitpotxEfi(
)'htob'ro'tuo'
8ot2
)'smb'=noitpotxEfi(
A/NseYseY
ehtsserP:edoMtidErotarepOmorftixeoT EDOM edomderisedehtlitnuyldetaepernottub
sserpnehT'ESAB'.g.e,deyalpsidsiegassem LLORCS .
4.1 Selecting a program
In order to change the selection of a program when the SX100e is operating as a stand-alone
controller, it is necessary to enter 'OPERATOR EDIT' mode.
If it is necessary only to change the program selected, refer to Table 2 below.
Table 2 SX100e Operator edit mode
4.2 Defining a program
Follow the instructions on Table 3 below to select a new program, and/or to change the
parameters of the required programs as indicated.