T-COMVB
..........page8-11
Charging the BluetootlYDevice
Before using this device, fully charge the Bluetooth“device.
1.
Insert the USB plug of the charging cable into the small USB jack on the
headset. Insert the other end of the charging cable into the Power Adaptor or
your computer’s USB port.
2. While charging, the red LED on the headset module will illuminate, when the
charging is finished, the red LED will switch off. A normal charge from a low
battery will take about 4 hours.
Tip: To maintain long life from the internal polymer battery, charge your
device at least once each month.
Powering 0n and Off
1.
To turn the device on, press the Power/Intercom button for 3 seconds until
you hear a beep. a blue light will flash quickly 3 times and then continue short
flashes at regular intervals.
2.
To turn the device off, press the Power/intercom button for 5 seconds until
you hear a beep. The headset and LED lights will turn off.
Pairing to your BluetootéEnabled
Mobile Phone
1.
Place your Bluetooth”enabled phone and the Bluetootlfreceiver near each
other (within 1m).
2.
Make sure the Bluetooth°receiver is turned off.
To Next Page