6.7.1.1 Profile Information
The Profile Information screen contains customer and vehicle information for a specific
transmission. It saves in the TCU and PC. This is used to identify different tuning profiles from
each other and it does not affect any tuning on the Transmission.
6.7.1.2 Engine Configuration
Cylinders – Number of cylinders on the engine can be typed in this block. It is not used by the
current firmware but reserved for future development of different firmware.
Engine Idle RPM – Idle RPM of the engine can be typed in this block. It is used by the firmware to
release the lockup clutch if the revs fall below this value plus 200 RPM. Example if you select 600
the lockup will release below 800 RPM’s.
Engine Max RPM – Maximum RPM of the engine can be typed in this block. It is used scale the
gear profile graphs so that the whole graph can be used for tuning.
RPM Pulses / Revolution – This setting is the number of RPM pulses per engine revolution that
the TCU receives. It is used for correct revolution calculation and display.
To Next Page
Loading...