6.7.1.3 Transmission Configuration
Number of Gears – This setting tells the software how many forward gears the transmission has.
In some firmware profiles, this setting is forced and cannot be changed. The user may select fewer
gears for specific profiles like low range etc.
Converter Stall Speed – This setting is used in some firmware programs to control the lockup
minimum engage RPM’s.
Number of Shift Solenoids – This setting tells the software how many shift solenoids the
transmission has. In most firmware profiles, this setting is forced and cannot be changed.
Maximum Speed – This setting is used to adjust the speedometer maximum speed display.
Speed Sensor Pulses / Rev – This setting is the number of pulses per prop shaft revolution, that
the Speed sensor sends to the TCU. It is used for correct speedometer calculation in conjunction
with the Speedometer Calibration value.
TCC Off TPS High – When the throttle is pressed more than this setting in %, the lockup will be
switched off. This will protect the TCC with hi torque engines.
TCC Off TPS Low – When the throttle is released more than this setting in %, the lockup will be
switched off. This will smooth the down shifting of the Transmission.
The last two features can be made 0% and 100% to deactivate if you require the lockup to stay on.
6.7.1.4 General Purpose Outputs
To Next Page
Loading...