Spitronics TCU Standard - 6.7.3 Solenoid Setup (Alt 2)

for Tiptronic while the Red LED is On when the Lockup clutch is engaged. In Gear Mode the Red
LED indicates if Shift Solenoid no 1 is engaged and the Green LED indicates if Shift Solenoid no 2
is engaged. This is handy to see if and when the TCU shift between different gears.
6.7.3 Solenoid Setup (Alt 2)
These options are used to set up different Shift Solenoid configurations for each shifter position,
as well as the different gears in the shifter positions, if they are allowed. Most firmware is
preprogrammed and will not allow the user to change any of these settings.
6.8 Profiles (F3)