What to do if my Spitwater HC11140P engine does not start?
If the engine of your Spitwater Pressure Washer doesn't start, first check the fuel level and add fuel if necessary. Also, if your model is fitted with a low-level water sensor, ensure the water supply is turned on. If neither of these solutions works, contact a Spitwater service agent.
How to fix Spitwater HC11140P Pressure Washer when pump runs but does not reach rated pressure?
If your Spitwater Pressure Washer's pump is running but not reaching the expected pressure, it might be due to the pump sucking air. Inspect the hose and fittings for any leaks. Another possible cause is a blocked nozzle; remove and clean it. Also, a dirty water filter can be the culprit, so check and clean the water filter.
Why is the pressure fluctuating on my Spitwater HC11140P Pressure Washer?
Fluctuating pressure in your Spitwater Pressure Washer can occur if the pump is sucking air. Check the hose and fittings for leaks. Another cause could be a dirty water filter, so inspect and clean it.
How to reduce noise from Spitwater HC11140P Pressure Washer pump?
A noisy pump in your Spitwater Pressure Washer can be caused by the pump sucking air, so check the hose and fittings for leaks. Additionally, if the water inlet temperature is too high, reduce the water temperature.
General| Model | HC11140P |
|---|---|
| Category | Pressure Washer |
| Pressure | 4000 psi |
| Nozzles Included | 5 |
| Flow Rate | 15 L/min |
| Hose Length | 10 meters |
| Dimensions | 1100 x 600 x 900 mm |
To Next Page
