5
Surround Monitor Controller 2489
IMPORTANT: Adjust the voltage setting on the rear panel so that it corre-
sponds to your local power conditions. Before connecting the SMC or any
other equipment turn off all power.
It makes good sense to think about where you place your SMC before connec-
ting it. It should be positioned so that you can easily reach it, but there are
other considerations. Try not to place it near heat sources or in direct sunlight,
and avoid exposure to excessive vibrations, dust, heat, cold or moisture. It
should also be kept away from transformers, motors, power amplifiers and
digital processors. In addition, please:
• Do not open the case. You may risk electric shock and damage to your equip-
ment.
• Leave repairs and maintenance to a qualified service technician. Should
foreign objects fall inside the case, contact your authorized dealer or
support person.
• To avoid electric shock or fire hazards, do not expose your unit to rain or
moisture.
• In case of lightning, unplug the unit. Always unplug the cable by pulling on
the plug only; never pull on the cable.
• Never force a switch or knob.
• Use a soft, lint-free cloth to clean the case. Avoid cleaning agents as they
may damage the unit.
The SMC‘s power supply was carefully engineered to provide clean and consis-
tent current – an important prerequisite for excellent audio. Built around a
toroidal transformer, the power supply generates a minimal electromagnetic
field with no hum or mechanical noise. The output side is filtered by an RC
circuit to extract noise and hums inherent in commercial AC power.
All audio-related components are fed by two separate voltage regulators to
minimize disturbance from other components.
An AC power cord is included for connection to the standard 3-prong IEC
connector. The transformer, power cord and IEC connector are VDE, UL and
CSA approved. The AC fuse is rated at 315 mA for 230 v and 630 mA for 115 v.
Before you begin
Power Supply
To Next Page
Loading...
