13
Filling and Starting Your Pool
1. Begin adding water to the pool. When the pool has approximately 1" of water on the bottom, shut the water off.
Gently pull on the foot straps to remove any remaining wrinkles. The sides will rise automatically and will be in
their proper position when the pool is full. Full position is when water level is approximately 3" from the top of
the pool.
2. When the pool is full, plug in the circulation system, making certain the Ball Valve is open (Handle is inline with
hose). You will begin to see water being pulled down into the skimmer. The pump basket area will also fill with
water, as seen through the clear lid. At the same time, the pressure gauge on top of the filter will show that
water is filling the tank.
3. At this time, “bleed” air from the circulation system by loosening the small threaded plug on the filter lid. You will
hear air escaping. Once all the air has escaped, water will follow. When this happens, retighten the plug. The
circulation system has now been primed.
4. Assemble the ladder, per instructions, and place it where desired in the pool. (Refer to page 19 for Ladder
Assembly Instructions.)
5. Start enjoying your pool.
WARNING: SHALLOW WATER!
NEVER JUMP OR DIVE INTO A SPLASH
SUPERPOOL!
WARNING: NEVER work on pump, filter or skimmer
while pump is operating or serious injury could
occur due to strong suction.
©
2003-Splash Superpools Ltd.
To Next Page
Loading...