Need help?Do you have a question about the Splash SuperPools SuperPool and is the answer not in the manual?
General| Brand | Splash SuperPools |
|---|---|
| Model | SuperPool |
| Category | Swimming Pool |
| Language | English |
Prepare the site, unfold the pool, and position the pump and filter, noting safety warnings.
Insert and connect top rails into pool pockets, aligning pre-punched holes for stability.
Assemble legs, insert into top rails, and connect to pool buttress straps.
Secure walls, ensure wrinkle-free installation, position rails, and verify leg support and insertion.
Install wall fittings, skimmer, eyeball fitting, pump, and filter according to instructions.
Secure connections, prepare fittings, attach hoses, and place warning labels.
Instructions for installing a second skimmer, including Tee fittings and hose connections.
Add water to 1 inch, remove wrinkles, and allow sides to rise, filling to 3 inches from the top.
Plug in the circulation system when the pool is full and verify water flow to the skimmer and filter.
Bleed air from the system by loosening the filter lid plug until water appears, then retighten.
Assemble the ladder according to instructions and place it in the desired location.
Prepare the ground, clear debris, ensure level, spread pool, and align with outlet.
Assemble structure tubes, connect them to uprights, and attach the skimmer.
Attach wall fittings, skimmer weir, connect hoses, and ensure proper hose installation.
Connect the pump and filter, then fill the pool with water.
Manually vacuum the pool using a hose, head, and pole, following safety precautions.
Use an automatic cleaner by attaching a vacuum adapter plate to the skimmer and connecting the hose.
Clean the sand filter by backwashing, ensuring water is clear before returning to filter mode.
Clean the cartridge filter by removing, cleaning, and replacing the filter element and canister.
Clean the pump basket by removing the lid, cleaning the basket, and replacing the lid.
Identify all parts included in the SplashLadder kit before beginning assembly.
Assemble the ladder top section and the waterside steps using the provided components.
Assemble the outside steps and connect the ladder top with the waterside steps.
Attach the ladder to outside legs and complete the final ladder assembly.
Attach the berth pipe and secure the ladder to the pool's buttress leg.
Install the safety strap and warning label for proper ladder operation and safety.
Attach the OmegaLadder berth pipe to the pool's buttress leg using mounting brackets and screws.
To Next Page