Winterizing your Splash Pool
21
CAUTION: Failure to lower water level
could result in ice damage to your pool.
To help guide you in the winterizing process of your Splash Pool, instructions are as follows:
1. The use of winterization chemicals will greatly improve the condition of your water when opening the pool in the
spring. These chemicals should be available through your Splash dealer.
2. Disconnect the Skimmer and remove it and all hoses from inside the pool. The Skimmer Wall Fitting will need
to be plugged from inside the pool, and the Slice/Ball Valve should be opened to allow it to drain. (The valve
can be removed, but must be free of water for the winter.)
3.
Drain the water below the Return Fitting, remove the Directional Fitting and do not plug the Wall Fitting. This
will help to maintain the low water throughout the winter.
4. All Hoses which connect the pump and filter to the pool should be removed at this time. Properly store the
Pump, Filter and Hoses for use next season.
5. Place pillows in the pool and secure to sides, then apply winter Cover (available as an accessory). Splash
Covers are made especially for our pools and come complete with bungee cords for fastening.
6. Damage to the pool from ice is not covered by the warranty. Some areas may dictate additional precautions.
Note: If your area does not experience freezing temperatures, disregard items 2-6.
Accessories
Visit the Splash web site (www.splashpools.com) for a complete line of accessories available for the Splash family
of pools.
©
2003-Splash Superpools Ltd.
To Next Page
Loading...