Please note that SIP providers do not accept Overlap Dialling (default) therefore the LCR Plan entries
routed to a SIP trunk must be configured to collect the digits and send them en-bloc, similar to the
following example for dialling national numbers.
Using the SIP “From” Field
In general this field is left blank however if a provider requires certain information to be presented the
following should be taken into account.
The
maximiser syste
m presents <p
resentation numb
er> <ac
count number>@<m
odule a
dd
ress>
If alternative information is required the follow text strings can be used:
%s = presentation number (e.g. 441923282200)
%c = account number (e.g. 00001234567)
%u = user (e.g. Sam Jones)
so a blank entry is equivalent to:
%s %c@<module address> eg 441923282200@sip.provider.net
An example entry in the SIP “From” Field:
%s@ims.telekomsrbija.com
(To ensure the CLI number is presented)
DDI Plans
Please note:
If the number dialled by the incoming caller is not matched in the relevant DDI Plan the call will be
routed by the Dial Plan configured for the Trunk receiving the call.
To Next Page
Loading...
