Data di emissione: Dicembre, 2017 Revisione: 1 Pag. : 26/40
9. MECHANICAL CONTROL BOARD
a) Activate the general switch (D);
b) Each tank is controlled by three switches
which are activated as follows:
- In order to make ice slush or sorbets:
first select the switch (E) to start up the mixer
components (the green LED on the switch will
light up to confirm the selection has been
made), then select the switch (F) to activate the
cooling system.
- In order to make cold drinks: first select
the switch (E) to start up the mixer components
(the green LED on the switch will light up to
confirm the selection has been made), then
select the switch (G) to activate the cooling
system at a positive temperature.
- In order to clean the machine: select
only the switch (E) in order to to start up the
mixer components without the intervention of
the refrigerating system.
c) The (H) switch controls the covers’ LED
lights.
! Warning !
If the machine is turned off at night, with the
bowls filled, or just partially filled, a layer of
solid ice may form on the surface, due to the
natural separation of the unmixed product. In
this case, before turning the machine back on, it
is necessary to verify for the product complete
melting in order to prevent damage to the
mixing auger.
To Next Page
Loading...
