SPM Karma - Page 36

Date of issue: January 2018 Revision 1 Page 36/48
- Remove the device that gives the star-shaped
form to the ice cream from the flange (fig. 20).
- Extract the beater and all components
mounted on it (fig. 21).
- Dismantle the beater as shown in fig. 22 and
23, taking care to remove all the components
listed below:
 Central shaft L (fig.22);
 Two scrapers N (fig.22);
 The two rear seals M and O (fig.23).
- Dismantle the two rear seals M and O into its
two component parts, the bushing and the
rubber cup gasket (fig. 24).
- Wash each of these components thoroughly
with hot water and washing-up liquid.
Fig. 20
Fig. 20
Fig. 21
Fig. 22
Fig. 23