Begin my inserting the bottom
strap through the designated
hole at the bottom of the tank
blow mold.
1
Once inserted, tilt the buckle
upward and insert on the
underside of the buckle and pull
through.
2
Once pulled through, insert
again through the top side of the
buckle and pull through.
3
The bottom strap can then be
tightened once attached. Repeat
Steps 1-4 on the other side.
4
Loop the top strap through the
designated blow mold opening
found on top of the tank.
5
Insert the top strap through the
underside of the buckle and pull
through completely.
6
Loop the strap back through the
opening located on the upper
side of the buckle.
7
Tighten once inserted by pulling
upward on the strap and repeat
on the other side.
8
STEP 1.
ASSEMBLING YOUR SPRAYER
Copyright © WESSOL, LLC
10
TORNADO | SMSASM Operation Guide
To Next Page
Loading...
